Husqvarna Rider 213C Workshop Manual page 23

different wheels. Do not mix parts from different
wheels.
1. Put supports below the product. Refer to
supports below the product on page 6 .
2. Remove the protective cap.
3. Remove the snap ring.
4. Pull off the wheel from the axle.
5. Collect the spacer sleeve and washers from the
axle.
6. Install in opposite sequence.
9.1.6 Rear axle
9.1.6.1 To disassemble the pivoting rear axle
Note: Do step 1-3 on AWD models only.
1. Make marks on the hydraulic hoses. This makes it
easier to connect them correctly when you assemble
the pivoting rear axle.
2. Put a container below the couplings of the hydraulic
hoses.
3. Disconnect the hydraulic hoses from the couplings
below the product.
934 - 002 - 25.06.2019
4. Put supports below the product in front of the
articulated steering.
To put
5. Disassemble the rear wheels.
6. Loosen the locknuts (A) of the steering cables.
7. Hold the cable with a wrench and remove the
adjuster nuts (B).
8. Remove the idler spring.
9. Remove the ball joint for the speed control (A).
B
10. Remove the clamp on the speed control cable (B)
from the rear frame.
A
A
Repair instructions - 23
B
A
B