Husqvarna Rider 213C Workshop Manual page 14

3. TRANSMISSION, CONTROLS AND DRIVE SYSTEM
Do a check of/adjust front and rear wheel speed, AWD models only
Do a check of the oil in the transmission and fill if it is necessary. Refer to
a check of the transmission oil level on page 29 .
Make sure that the tire pressure is correct. Refer to
Examine and adjust the parking brake.
Replace oil filter in the transmission.
Replace the spin-on filter of the servo.
Replace the oil in the transmission. Refer to
rear hydrostatic transmissions on page 45 .
4. CUTTING EQUIPMENT
Clean the outer and inner surfaces of the cutting deck and the cutting deck cov-
ers.
Do a check of and adjust the cutting height.
Do a check of and adjust the parallelism of the cutting deck.
5. LAST INSPECTION AND DOCUMENTATION
Do a check of and adjust the engine speed, rpm. Refer to
page 59 .
Make sure that the product does not move in neutral position.
Do a check of the forward drive and the rearward drive on different speeds.
Do a check of the blade engagement, seat, lift and forward drive/brake. Refer to
Operation conditions on page 12 .
Do a check of the grass collector system, when applicable.
14 - Maintenance schedule for the
service center
Technical data on page 59 .
To replace the oil in the front and
Technical data on
First serv- Maintenance interval
icing in hours
50
O
To do
O
O
O
O
O
First serv- Maintenance interval
icing in hours
50
O
O
O
First serv- Maintenance interval
icing in hours
50
O
O
O
O
O
934 - 002 - 25.06.2019
100 200
O
O
O
O
O
O
O
100 200
O
O
O
100 200
O
O
O
O
O