Hydraulic System - Husqvarna R 214C Workshop Manual

6. Put the end of the hose into the container and empty
the fuel tank.
7. Remove the cable and lift the fuel tank.
9.4.3 To assemble the fuel tank
WARNING: Gasoline is very flammable and
dangerous for the environment. Make sure to
prevent fires and prevent spills.
CAUTION: Make sure the hose is not damaged.
Note: Empty the tank before assembly to make the
assembly easier.
1. Push the fuel hose through the bracket and put the
tank on the bracket.
2. Attach the cable around the tank.
3. Push the fuel hose through the frame.
4. Attach the fuel hose to the fuel filter.
5. Fill the tank with gasoline and do a check that there
are no leaks.
6. Attach the fender.

9.5 Hydraulic system

9.5.1 Oil leaks
WARNING: Oil is dangerous to the environment
and leakage can cause damage to the lawn.
CAUTION: Oil leakage can cause damage to
the transmission and make it wear it out faster.
Repair oil leaks immediately.
9.5.2 To bleed the drive system
CAUTION: Air can go into the system. Do not
run the transmission oil tank empty while you
bleed the drive system. Fill the transmission oil
tank fully when it is filled.
1592 - 002 - 11.02.2021
CAUTION: Do not operate the speed pedals
when the controls for the clutch valves is
disengaged.
1. Put the product on the adjustment tool for wheel
Servicing tools on page 16
speed. Refer to
2. Attach an exhaust hose if you preform this
procedure indoors.
WARNING: Engine exhaust contains
poisonous carbon monoxide.
3. Remove the transmission cover.
4. Open the clutch valve.
Note: There are 2 valves on AWD products.
5. Fill the transmission oil tank with oil. Wait some
minutes and fill the transmission oil tank again.
6. Start the engine and let it run at idle speed.
7. Fill the transmission oil tank until the oil level does
not decrease.
8. Release the parking brake.
9. Operate the forward and rearward pedals for 4–5
times each.
10. Fill the transmission oil tank if it is necessary.
Repair instructions - 31