WARNING: Engine exhaust contains
poisonous carbon monoxide.
4. Fill the transmission tank with oil. Wait some
minutes and fill the transmission oil tank again.
5. Make sure that the clutch valves are closed.
6. Start the engine and let it operate at idle speed. Fill
the transmission oil tank again.
7. Release the parking brake and operate the front and
rearward pedals for 4 – 5 seconds, fill the
transmission oil tank again.
8. Operate the forward and rearward pedals for 4 – 5
seconds.
9. Fill the transmission oil tank if it is necessary.
10. Release the pedals.
11. Operate the forward and rearward pedals. Make
sure that the wheels start to turn immediately.
38 - Repair instructions
Max
Min
12. Move the product on the adjustment tool for wheel
speed and do a test.
13. Fill the transmission oil tank if it is necessary.
14. Attach the transmission cover.
9.5.9 Drive shafts
9.5.9.1 To disassemble the front transmission
Do not disassemble the tool frame.
To keep the hydraulic system
Obey the instructions in
clean on page 36 .
CAUTION: Hold the hydraulic connection nuts
with a wrench to prevent damage to the pipes or
elbow nipples.
Note: Oil leakage from pipes and hoses can occur
although the transmission is drained.
1. Remove the cutting deck. Refer to
attach the cutting deck on page 8 .
2. Put support below the product. Refer to
supports below the product on page 6 .
3. Remove the front wheels. Refer to
install the wheels on page 22 .
4. Remove the front speed adjustment rod from the
front transmission.
5. Drain the oil.
To remove and
To put
To remove and
934 - 002 - 25.06.2019