Fuel System; Hydraulic System - Husqvarna R 214T Workshop Manual

Hide thumbs Also See for R 214T:
Table of Contents

Advertisement

9.4 Fuel system

9.4.1 To replace the fuel filter
1. Open the engine cover to get access to the fuel
filter.
2. Compress the fuel tank hose to prevent leakage.
3. Move the hose clips away from the fuel filter with a
pair of flat pliers.
4. Pull off the fuel filter from the hose ends. A small
quantity of fuel can leak.
5. Push the new fuel filter into the ends of the hoses.
Apply liquid detergent to the ends of the fuel filter to
make the connection easier.
6. Push the hose clips against the fuel filter.
9.4.2 To remove the fuel tank
WARNING: Gasoline is very flammable and
dangerous for the environment. Make sure to
prevent fire and spill.
1. Remove the fender above the fuel tank. See
remove the covers on page 18
2. Put a container below the fuel tank to collect the
gasoline. For information about fuel tank capacity,
Technical data on page 51
see
3. Compress the fuel tank hose to prevent leakage.
32 - Repair instructions
4. Disconnect the fuel tank hose from the lower
connection of the fuel filter.
5. Pull the hose through the frame.
6. Put the end of the hose into the container and empty
the fuel tank.
7. Remove the cable and lift the fuel tank.
9.4.3 To install the fuel tank
WARNING: Gasoline is very flammable and
dangerous for the environment. Make sure to
prevent fires and prevent spills.
CAUTION: Make sure the hose is not damaged.
Note: Empty the tank before assembly to make the
assembly easier.
1. Push the fuel hose through the bracket and put the
tank on the bracket.
2. Attach the cable around the tank.
3. Push the fuel hose through the frame.
4. Attach the fuel hose to the fuel filter.
5. Fill the tank with gasoline and do a check that there
are no leaks.
6. Attach the fender.

9.5 Hydraulic system

9.5.1 Oil leaks
WARNING: Oil is dangerous to the environment
and leakage can cause damage to the lawn.
CAUTION: Oil leakage can cause damage to
the transmission and make it wear it out faster.
Repair oil leaks immediately.
9.5.2 To bleed the drive system
CAUTION: Air can go into the system. Do not
run the transmission oil tank empty while you
bleed the drive system. Fill the transmission oil
To
tank fully when it is filled.
1676 - 001 - 26.11.2021

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

R 214tc

Table of Contents