Husqvarna Rider 213C Workshop Manual page 34

3. Carefully push in the lock mechanism and tilt the
lamp to remove it from the brackets.
4. Put the new lamp in the lower slot on the lamp
housing. Use the type of lamp as given in
data on page 59 .
5. Push the lamp into the lock mechanism.
6. Put the lower end of the lamp cover into the slots on
the steering column.
34 - Repair instructions
7. Connect the cables to the new lamp.
8. Attach the lamp cover and tighten the screws.
9.3.6 To remove and install the operator presence
Technical
control (OPC)
1. Lift the seat and remove the screw that hold the
spring and spring washer.
2. Release the OPC holder.
3. Disconnect the cable connections from the OPC.
4. Press in the fasteners and remove the OPC from the
holder.
5. Install in opposite sequence.
9.3.7 To adjust the microswitch for the parking
brake pedal
1. Remove the transmission cover. Refer to
the covers on page 20 .
2. Do a check of the adjustment of the hydrostatic
transmission cable. Refer to
hydrostatic transmission cable on page 44 .
3. Remove the frame tunnel cover. Refer to
the covers on page 20 .
To remove
To adjust the
To remove
934 - 002 - 25.06.2019