Table of Contents
Advertisement
Description
Setting
• • •
Program overview
Example:
Important
Example
68/348
Siemens Building Technologies
HVAC Products
3.15 Switching times
This is the setting of the switching times for d.h.w. time switch program at which the
d.h.w. temperature setpoint will change.
The time switch program thus set is activated by pressing the d.h.w. operating mode
button
.
Setting range
- -:- - / 00:00...24:00
Line
Switching point
Switch-on time period 1
Switch-off time period 1
Switch-on time period 2
Switch-off time period 2
Switch-on time period 3
Switch-off time period 3
The principle is the same as that used with "Time switch program space heating"; refer
to operating lines 6...1.
When solar collectors (with heat exchanger in the d.h.w. storage tank) or a wood-fired
boiler is used, the d.h.w. storage tank should not be charged during the day by the
controlled heat sources to ensure that the solar energy or energy delivered by the
wood-fired boiler can still be accommodated in the d.h.w. storage tank.
The switching times must be appropriately set.
A setting example could look as follows:
[°C]
0
4
6
2
26
Nominal setpoint TBWw of the d.h.w. temperature
770
Reduced setpoint TBW
Basic Documentation RVP540 / RVP550
Description of the enduser settings
Unit
h : min
D.h.w temperature setpoint
Nominal setpoint
Reduced setpoint
Nominal setpoint
Reduced setpoint
Nominal setpoint
Reduced setpoint
8
10
12
14
of the d.h.w. temperature
R
Factory setting
See "Program overview"
below
Standard
06:00
22:00
– – : – –
– – : – –
– – : – –
– – : – –
16
18
20
22
24
CE1P2488en
t [h]
18.10.2002
Advertisement
Table of Contents
