Appendix B: Error Indicator - Mitsubishi Electric KD Series User Manual

LED indicator on this product shows this product's status (refer to Chapter 4-2) and
Error indications based on register values (refer to Chapter 5-2-19).
The details of this error indicator are described in below.
Item
After power on, a part of status LED keeps
indicating Red and Orange alternatively.
1
After power on, all of status LED keeps
indicating Red and Orange alternatively.
2
After power on, the status LED keeps
indicating Orange continuously.
①Ch1 - 4: Solid orange
②Ch1 - 3: OFF Ch4:Solid orange
③Ch1 - 2: OFF Ch3 - 4:Solid orange
3
④Ch1: OFF Ch2 - 4:Solid orange
①
All status LED indicates Red.
4
TM－XJ101C

Appendix B: Error indicator

Status
② ③ ④
Contents of errors and necessary treatment
This status shows a failure of the connection with your frame grabber
over CXP link and a status of keeping "CXP link establishing".
Please check the following point.
①Is CoaXPress® cable whose status LED indicates the error unplugged?
This status shows a failure of the connection with your frame grabber
over CXP link. Please check the following points.
①Is CoaXPress® cable whose status LED indicates the error unplugged?
②Is the setup of your frame grabber completed correctly?
This status shows a failure of System-boot operation of this product. If an
appropriate voltage is not provided to CIS, this status happens. Please
check the following points.
①Is the pin assignment (5V or GND) of V1/V3 connectors of DC5V
correct? (If +5V and GND pins specified on the pin assignment table are
not connected, the sensor board cannot operate correctly.
②Is the current limiter setting of your DC5V power unit too low when
power on?
③Is the voltage of DC5V less than 4.75V?
If you don't see any of them above, CIS might be broken or damaged.
This status shows an abnormal temperature of FPGA on /F board. Make
sure if the surrounding temperature of this product is too high.
When necessary, prepare additional cooling solution to this product.
CoaXPress® is a trade mark registered by JIIA (Japan Industrial Imaging Association).
90
© Mitsubishi Electric Corporation