Status Led - Mitsubishi Electric KD Series User Manual

4-2-1 Status LED

L1(KD6R367CX / CX-NL)
L2(KD6R587CX / CX-NL / CXS)
L3(KD6R807CX / CX-NL)
Ch1: D1 or D5
Ch2: D2 or D6
Ch3: D3 or D7
Ch4: D4 or D8
TM-XH719C
4-2 Status LED
LED status CIS Status
LED off No power
Orange Detecting link
Rapid blink
Red and orange CXP link
alternate blink establishing
Green Link established,
LED on no stream transfer
Green Rapid Link established,
blink transferring stream
Red 0.5 sec. CRC error
LED blink
COPYRIGHT©2017-2020 MITSUBISHI ELECTRIC CORPORATION. ALL RIGHTS RESERVED.
【Status LED】
Status LED is located on the back of CIS.
Status LED shows the status of communication status and
CIS.
【 Communication status of CoaXpress® 】
Each LED shows the communication status of CoaXpress®
connectors.
【 Status of CIS 】
Combination of the 4 status LED shows the status of CIS.
LED status
Ch1 to 4: Red LED on
Ch1 to 4: Orange LED on
Ch1 to 3: OFF
Ch4: Orange LED on
Ch1 to 2: OFF
Ch3 to 4: Orange LED on
Ch1: OFF
Ch2 to 4: Orange LED on
CoaXpress® is a trade mark registered by JIIA (Japan Industrial Imaging Association).
CIS Status
FPGA abnormal
temperature of I/F board
System boot
(FPGA configuration
of I/F board)
System boot
(FPGA reset status
of I/F board)
System boot
(Setting CLK Gen
of I/F board)
System boot
(CIS booting up)
67