Modifying Acknowledgment Settings - Lutron Electronics RadioTouch RTA-RS232 Setup And Installation Manual

Advanced Programming

Modifying Acknowledgment Settings

The Acknowledgment setting should remain OFF unless you have a special requirement to control multiple rooms
from a master host device. In this mode an ACK will be returned when a command has been completely sent via
RF from the desired Interface. If you need to use this feature contact the Lutron technical Support Center at
1-800-523-9466, for more details then continue with the following section.
Step A:Enter unit configuration mode by pressing and
holding the mode and address buttons for 5
seconds. The LED display will begin flashing
UC when the unit has entered unit
configuration mode.
OR
See the RTA-RS232 Setup Guide for interface
Optional Terminal
programming and operation instructions. For
Block Connector
additional system details consult the
RadioTouch Installers Guide, which is
TM
1 2 3 included with each RadioTouch
RadioTouch is a trademark of Lutron Electronics Co., Inc.
This product may be covered by one or more of the following
U.S. patents: 5,248,919; 5,399,940; 5,736,965; 5,798,581;
5,838,226; 5,848,054; 5,905,442, 5,982,103
For additional assistance call the Lutron Technical
(800) 523-9466.
Support Center at
OR
See the RTA-RS232 Setup Guide for interface
Optional Terminal
programming and operation instructions. For
Block Connector
additional system details consult the
RadioTouch Installers Guide, which is
TM
1 2 3 included with each RadioTouch
RadioTouch is a trademark of Lutron Electronics Co., Inc.
This product may be covered by one or more of the following
U.S. patents: 5,248,919; 5,399,940; 5,736,965; 5,798,581;
5,838,226; 5,848,054; 5,905,442, 5,982,103
For additional assistance call the Lutron Technical
(800) 523-9466.
Support Center at
Controller.
TM
P/N 500-9258 Rev A
Controller.
TM
P/N 500-9258 Rev A
Step B:Once UC is flashing press the mode button
until the display shows AC.
OR
See the RTA-RS232 Setup Guide for interface
Optional Terminal
programming and operation instructions. For
Block Connector
additional system details consult the
RadioTouch Installers Guide, which is
TM
1 2 3 included with each RadioTouch
RadioTouch is a trademark of Lutron Electronics Co., Inc.
This product may be covered by one or more of the following
U.S. patents: 5,248,919; 5,399,940; 5,736,965; 5,798,581;
5,838,226; 5,848,054; 5,905,442, 5,982,103
For additional assistance call the Lutron Technical
(800) 523-9466.
Support Center at
Once the display shows AC press the enter
button and the current acknowledgment
setting will be displayed on the right LED
display.
OR
See the RTA-RS232 Setup Guide for interface
Optional Terminal
programming and operation instructions. For
Block Connector
additional system details consult the
RadioTouch Installers Guide, which is
TM
1 2 3 included with each RadioTouch
RadioTouch is a trademark of Lutron Electronics Co., Inc.
This product may be covered by one or more of the following
U.S. patents: 5,248,919; 5,399,940; 5,736,965; 5,798,581;
5,838,226; 5,848,054; 5,905,442, 5,982,103
For additional assistance call the Lutron Technical
(800) 523-9466.
Support Center at
• Continued on next page.
RadioTouch Setup Guide for RTA-RS232
TM
Controller.
TM
P/N 500-9258 Rev A
Controller.
TM
P/N 500-9258 Rev A
35