Lutron Electronics RadioTouch RTA-RS232 Setup And Installation Manual page 38

Operation
Step D:Adjust light levels to the desired levels.
First, enter Preset Adjust Mode by using the
PSA command or put Dip Switch #1 in the
down position on each controller.
Flip Dip Switch #1 to the Down position on
each controller or issue the Preset Adjust
Mode command.
:PSA,9,ENTER<CR>
~OK
RadioTouch RTA-RX-F-SC
TM
Radio Frequency
LISTED 243C
Controller
Ind. Cont. Eq.
Coopersburg, PA 18036
RECEIVER SWITCH SETTINGS STATUS INDICATOR OPERATION
1. UP-Preset Lock DN.-Preset Adj. ON - Burn-in Mode
2. UP-Occ. Sensor DN.-Emerg. Set.
Slow Blink -Normal Operation Mode
3. UP-FDB Mode DN.-ECO Mode
Fast Blink - Program
4. UP-OFF DN.-Min. Light
Very Fast Blink - Receiving RF Data
5. UP-Auto ON DN.-Manual ON
Powered Status
Program
Settings When Lit Indicator Button
1 2 3 4 5
See Installers Guide for
System Addressing and
Programming Instructions
1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16
0-10 V Shade Switch Closures
Occ. Sensor
Class 2 wiring connections shown above.
Power Status Program
1 2 3 4 5
1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16
CLASS 2 LOW VOLTAGE WIRING
Next, adjust each zone to the desired level
either by issuing explicit commands, or by
using RAISE/LOWER. Presets cannot be used
to adjust the light intensity.
Adjust Zone #0 to 25%, Zone #1 to 80%, and
Zone #2 to 50%. Issue an explicit level
command for each zone:
:XC,0,25<CR>
~OK
:XC,1,80<CR>
~OK
:XC,2,50<CR>
~OK
38 RadioTouch Setup Guide for RTA-RS232
TM
Burn-in
Button
Flip DIP switch #1 to
the down position
Burn-In
Step E: Select a preset to contain the scene
settings and save the Zone Levels to the
Preset.
Select a Preset to store the lighting levels for
that particular scene. Using Presets 1–5 will
allow the presets to be accessed and modified
from a Tabletop or Wall Control. Once a
Preset has been selected, save the current
Zone levels to that preset.
For this scene, we will use Preset #4. With the
RF Controller still in Preset Adjust Mode, issue
the Set Preset Command:
:SPS,9,4<CR>
~OK
Now, return Dip Switch #1 to the Up position
on each RF Controller or exit the Preset Adjust
Mode.
:PSA,9,EXIT<CR>
~OK
The scene has now been programmed.
Step F: Access the Scene.
Recall the scene by issuing a Preset
command for the Zone that contains the
scene.
Our scene was stored in Zone #9, Preset #4.
So, to recall the scene issue the command:
:PS,9,4<CR>
~OK
If another scene containing the same lighting
zones is desired, the same process can be
used as above, starting with Step D, only
selecting a different Preset. If a scene
containing different lighting zones is desired,
the same process can be used, starting with
Step A, only selecting a different zone on the
RTA-RS232 and a different Preset.