Ack - Turning Acknowledgments On Or Off; Add/Delete - Adding Or Deleting The Rta-Rs232 To/From Rf Controllers; Rpt - Reporting Configuration Settings; Ack - Lutron Electronics RadioTouch RTA-RS232 Setup And Installation Manual

Configuration Commands
ACK – Turning Acknowledgments ON or OFF
This command turns Acknowledgment Mode ON or OFF. The default setting for Acknowledgment Mode is OFF.
:CON,ACK,[Status]<CR>
Status
Example:
:CON,ACK,ON<CR>
ADD/DELETE – Adding or Deleting the RTA-RS232 to/from RF Controllers
This command adds or deletes the RTA-RS232 to/from an RF Controller. In order to add or delete the RTA-
RS232, each RF Controller needs to be in program mode. See the RadioTouch
031-200, for more details.
:CON,[Function],[Zone Number]<CR>
Function
Zone Number
Example:
:CON,ADD,5<CR> Adds Zone #5 of the RTA-RS232 to an RF Controller
RPT – Reporting Configuration Settings
This command allows the host to inquire about the configuration settings of the RTA-RS232 unit. See page 28 for
the RTA-RS232 responses to configuration inquiries.
:CON,RPT,[Category],{Parameter}<CR>
Category
Parameter
Examples:
:CON,RPT,TYPE,2<CR> Requests the zone configuration for zone #2.
:CON,RPT,RB<CR> Requests the status of Reply Back Mode.
ON Turns Acknowledgment Mode ON
OFF Turns Acknowledgment Mode OFF
Turns Acknowledgment Mode ON
ADD Adds RTA-RS232 Zone to RF Controller

DELETE

Deletes RTA-RS232 Zone to RF Controller
0 – 9 Affected Zone
TYPE Zone type
HAND Data Flow Control configuration
RB Reply Back Mode

ACK

Acknowledgment Mode
REV Software Revision
0 – 9 Desired Zone (Applies only to TYPE)
M Master microprocessor (Applies only to REV)
S Satellite microprocessor (Applies only to REV)
Installer's Guide, part number
TM
RadioTouch Setup Guide for RTA-RS232
TM
27