Modifying Reply Back Settings - Lutron Electronics RadioTouch RTA-RS232 Setup And Installation Manual

Advanced Programming

Modifying Reply Back Settings

The default mode is for the RS232 Interface to send OK and error messages back to the host device. If your
device is unable to process this information, continue with this section to turn Reply Back messages OFF.
Step A:Enter unit configuration mode by pressing and
holding the mode and address buttons for 5
seconds. The LED display will begin flashing
UC when the unit has entered unit
configuration mode.
OR
See the RTA-RS232 Setup Guide for interface
Optional Terminal
programming and operation instructions. For
Block Connector
additional system details consult the
RadioTouch Installers Guide, which is
TM
included with each RadioTouch
1 2 3
RadioTouch is a trademark of Lutron Electronics Co., Inc.
This product may be covered by one or more of the following
U.S. patents: 5,248,919; 5,399,940; 5,736,965; 5,798,581;
5,838,226; 5,848,054; 5,905,442, 5,982,103
For additional assistance call the Lutron Technical
(800) 523-9466.
Support Center at
OR
See the RTA-RS232 Setup Guide for interface
Optional Terminal
programming and operation instructions. For
Block Connector
additional system details consult the
RadioTouch Installers Guide, which is
TM
1 2 3 included with each RadioTouch
RadioTouch is a trademark of Lutron Electronics Co., Inc.
This product may be covered by one or more of the following
U.S. patents: 5,248,919; 5,399,940; 5,736,965; 5,798,581;
5,838,226; 5,848,054; 5,905,442, 5,982,103
For additional assistance call the Lutron Technical
(800) 523-9466.
Support Center at
Controller.
TM
P/N 500-9258 Rev A
Controller.
TM
P/N 500-9258 Rev A
Step B:Once UC is flashing press the mode button
until the display shows
OR
See the RTA-RS232 Setup Guide for interface
Optional Terminal
programming and operation instructions. For
Block Connector
additional system details consult the
RadioTouch Installers Guide, which is
TM
included with each RadioTouch
1 2 3
RadioTouch is a trademark of Lutron Electronics Co., Inc.
This product may be covered by one or more of the following
U.S. patents: 5,248,919; 5,399,940; 5,736,965; 5,798,581;
5,838,226; 5,848,054; 5,905,442, 5,982,103
For additional assistance call the Lutron Technical
(800) 523-9466.
Support Center at
Once the display shows
button and the current setting will be
displayed on the right LED display.
OR
See the RTA-RS232 Setup Guide for interface
Optional Terminal
programming and operation instructions. For
Block Connector
additional system details consult the
RadioTouch Installers Guide, which is
TM
1 2 3 included with each RadioTouch
RadioTouch is a trademark of Lutron Electronics Co., Inc.
This product may be covered by one or more of the following
U.S. patents: 5,248,919; 5,399,940; 5,736,965; 5,798,581;
5,838,226; 5,848,054; 5,905,442, 5,982,103
For additional assistance call the Lutron Technical
(800) 523-9466.
Support Center at
• Continued on next page.
RadioTouch Setup Guide for RTA-RS232
TM
.
Controller.
TM
P/N 500-9258 Rev A
press the enter
Controller.
TM
P/N 500-9258 Rev A
33