Configuration Commands; Enter/Exit Configuration Mode; Type - Setting The Zone Type; Rb - Turning Reply Back Mode On Or Off - Lutron Electronics RadioTouch RTA-RS232 Setup And Installation Manual

Configuration Commands

Configuration Commands

The following commands will configure the RTA-RS232 product. Each is prefixed with the CON command.
When setting the RTA-RS232 configurations, the host must first enter Configuration Mode on the RTA-
RS232. After completing the configurations, the host must then exit Configuration Mode on the RTA-
RS232. If the system is in Configuration Mode, the only commands that the RTA-RS232 will execute are
Configuration commands. All other commands will be ignored. Conversely, if the RTA-RS232 is not in
Configuration Mode, it will ignore all Configuration Commands.

ENTER/EXIT Configuration Mode

This command informs the RTA-RS232 to either enter or exit Configuration Mode.
:CON,[Command]<CR>
Command
Example:
:CON,ENTER<CR> Enters the RTA-RS232 unit into Configuration Mode
TYPE – Setting the Zone Type

This command sets the zone type to Lights, Sivoia

default zone type is Unassigned.
:CON,TYPE,[Zone Number],[Type]<CR>
Zone Number
Type
Example:
:CON,TYPE,5,L<CR> Sets the type for Zone #5 to Lights
RB – Turning Reply Back Mode ON or OFF
This informs the RTA-RS232 to turn Reply Back Mode ON or OFF. The default state of Reply Back Mode is ON.
(The RTA-RS232 issues a Prompt regardless of the state of RB, if the software flow control is turned ON.)
:CON,RB,[Status]<CR>
Status
Example:
:CON,RB,ON<CR> Turns Reply Back Mode ON
26 RadioTouch Setup Guide for RTA-RS232
TM
ENTER Enters the unit into Configuration Mode
EXIT Exits the unit from Configuration Mode
Motorized Shades, Contact Closures, or Unassigned. The
®
0 - 9 Zone Number whose type is to be set
L Sets the zone type to Lights
S Sets the zone type to Sivoia
C Sets the zone type to Contact Closure
- Sets the zone type to Unassigned
ON Turns Reply Back Mode ON
OFF Turns Reply Back Mode OFF
Motorized Shades
®