Lutron Electronics RadioTouch RTA-RS232 Setup And Installation Manual page 2

Notes on this Manual
This manual is an addendum to the RadioTouch
RS232 Interface is contained in this manual. For more information on programming the remainder of your
RadioTouch System, or for advanced features, refer to the RadioTouch
TM
Important Application Notes
The RadioTouch RS232 Interface is simply another transmitter in the RadioTouch
TM
Interface has the ability to communicate with up to 10 unique zones of lights, Sivoia
outputs in a single room. This device can not report the status of the lighting zones, Sivoia
closure outputs back to the host RS232 device.
Consumer Information
This symbol is intended to alert the user to the presence of important installation and operating instructions.
Danger
This RadioTouch system must not be used to control equipment, other than lighting, which is not visible from every
TM
transmitter location. It also must not be used to control equipment which could create hazardous situations such as
entrapment if operated accidentally. Examples of equipment which must not be controlled by this RadioTouch
include (but are not limited to) motorized gates, garage doors, industrial doors, microwave ovens, heating pads, etc. It is the
installer's responsibility to ensure that the equipment, other than lighting, being controlled is visible from every transmitter
location and that only suitable equipment is connected to this RadioTouch
FCC Information
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC rules. These limits are
designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio or television reception, which can
be determined by turning the equipment off and on. The user is encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Caution: Changes or modifications not expressly approved by Lutron Electronics Co., Inc. could void the user's authority to operate this equipment.
RadioTouch Installers Guide for RTA-RS232
TM
Installer's Guide. The procedures to setup a RadioTouch
TM
system.
TM
Installers Guide (P/N 031-200).
TM
System. The RS232
TM
shades, or contact closure
®
shades, or contact
®
TM
system
TM