Device Control Commands; Ps - Go To A Preset Level; Ps This Command Will Set The Indicated Zone To A Specific Preset Level - Lutron Electronics RadioTouch RTA-RS232 Setup And Installation Manual

Device Control Commands

RTA-RS232 Commands
PS – Go to a preset level
This command will set the indicated zone to a specific predetermined preset level.
:PS,[Zone Number],[Preset Number]<CR>
Zone Number
Preset Number
Example:
:PS,6,5<CR>
Preset Light Levels
16 preset light levels are available with the RS232 Interface. Presets 1–5 correspond to buttons on a
RadioTouch Wall Control (shown below) and will take the RF Controller to the same light level as a button press
TM
on the Wall Control. Presets 6–16 can be accessed only via the RS232 Interface.
Preset #1
Preset #2
Preset #3
Preset #4
Preset Sivoia Motorized Window Treatment Levels
®
Four (4) preset Sivoia Motorized Window Treatment presets are available with the RS232 Interface. Presets 1–4
®
correspond to buttons on the RadioTouch
treatments to the same position as a button press on the Wall Control. (ALLUP and ALLDOWN are explicit
commands, see XC – Explicit Command section on page 23.)
All Up
Preset #2
Preset #3
Preset #4
All Down
RTA-WX-S5SB
and SV-3P
Affected Zone (0-9)
Preset number for Affected Zone to go to (1-16)
Sets the level for Zone #6 to preset level #5
RTA-WX-5B
and Sivoia
TM
All Up
Preset #1
All Down
Preset #5
RTA-WX-2B and
RTA-WX-2BSW
Wall Controls (shown below) and will take the window
®
OPEN
All Up
PRESET
All Down
CLOSE
SV-1P
RadioTouch Setup Guide for RTA-RS232
TM
ON
OFF
OPEN
CLOSE
RTA-WX-S2LB
21