Lutron Electronics RadioTouch RTA-RS232 Setup And Installation Manual page 10

Hide thumbs Also See for RadioTouch RTA-RS232:
Table of Contents

Advertisement

Programming the RS232 Interface
Step 2
Continued
Step C:Using the left scroll button, select the zone
number which you would like to configure.
OR
See the RTA-RS232 Setup Guide for interface
Optional Terminal
programming and operation instructions. For
Block Connector
additional system details consult the
RadioTouch
Installers Guide, which is
TM
1 2 3
included with each RadioTouch
RadioTouch is a trademark of Lutron Electronics Co., Inc.
This product may be covered by one or more of the following
U.S. patents: 5,248,919; 5,399,940; 5,736,965; 5,798,581;
5,838,226; 5,848,054; 5,905,442, 5,982,103
For additional assistance call the Lutron Technical
(800) 523-9466.
Support Center at
Once the appropriate zone number is
displayed on the left LED display, use the
right scroll button to select the correct zone
type. [Lights (L), Shades (S), Closures (C), and
Unassigned (-).]
OR
See the RTA-RS232 Setup Guide for interface
Optional Terminal
programming and operation instructions. For
Block Connector
additional system details consult the
RadioTouch
Installers Guide, which is
TM
included with each RadioTouch
1 2 3
RadioTouch is a trademark of Lutron Electronics Co., Inc.
This product may be covered by one or more of the following
U.S. patents: 5,248,919; 5,399,940; 5,736,965; 5,798,581;
5,838,226; 5,848,054; 5,905,442, 5,982,103
For additional assistance call the Lutron Technical
(800) 523-9466.
Support Center at
10
RadioTouch
Setup Guide for RTA-RS232
TM
Controller.
TM
P/N 500-9258 Rev A
Controller.
TM
P/N 500-9258 Rev A
Once the correct zone number and type are
displayed, press the enter button to confirm
that this is the setting you require. The 3 LEDs
will flash to signal the change has been made.
OR
See the RTA-RS232 Setup Guide for interface
Optional Terminal
programming and operation instructions. For
Block Connector
additional system details consult the
RadioTouch
Installers Guide, which is
TM
included with each RadioTouch
1 2 3
RadioTouch is a trademark of Lutron Electronics Co., Inc.
This product may be covered by one or more of the following
U.S. patents: 5,248,919; 5,399,940; 5,736,965; 5,798,581;
5,838,226; 5,848,054; 5,905,442, 5,982,103
For additional assistance call the Lutron Technical
(800) 523-9466.
Support Center at
Step D:To configure more zones, go back to Step C
and start again.
Step E: Press the mode button to perform another
setup step or press and hold the address and
mode buttons for approximately 5 seconds to
exit unit configuration mode.
OR
See the RTA-RS232 Setup Guide for interface
Optional Terminal
programming and operation instructions. For
Block Connector
additional system details consult the
RadioTouch
Installers Guide, which is
TM
1 2 3
included with each RadioTouch
RadioTouch is a trademark of Lutron Electronics Co., Inc.
This product may be covered by one or more of the following
U.S. patents: 5,248,919; 5,399,940; 5,736,965; 5,798,581;
5,838,226; 5,848,054; 5,905,442, 5,982,103
For additional assistance call the Lutron Technical
(800) 523-9466.
Support Center at
Controller.
TM
P/N 500-9258 Rev A
Controller.
TM
P/N 500-9258 Rev A

Advertisement

Table of Contents
loading

Table of Contents