Table of Contents
Advertisement
Programming the RS232 Interface
Step 3
Continued
Step C:Press the left scroll button repeatedly until
the zone number you wish to address is
displayed.
OR
See the RTA-RS232 Setup Guide for interface
Optional Terminal
programming and operation instructions. For
Block Connector
additional system details consult the
RadioTouch
Installers Guide, which is
TM
included with each RadioTouch
1 2 3
RadioTouch is a trademark of Lutron Electronics Co., Inc.
This product may be covered by one or more of the following
U.S. patents: 5,248,919; 5,399,940; 5,736,965; 5,798,581;
5,838,226; 5,848,054; 5,905,442, 5,982,103
For additional assistance call the Lutron Technical
(800) 523-9466.
Support Center at
Then press the address button and the
display will show P with the zone number to be
programmed and the address LED will turn on.
OR
See the RTA-RS232 Setup Guide for interface
Optional Terminal
programming and operation instructions. For
Block Connector
additional system details consult the
RadioTouch
Installers Guide, which is
TM
1 2 3
included with each RadioTouch
RadioTouch is a trademark of Lutron Electronics Co., Inc.
This product may be covered by one or more of the following
U.S. patents: 5,248,919; 5,399,940; 5,736,965; 5,798,581;
5,838,226; 5,848,054; 5,905,442, 5,982,103
For additional assistance call the Lutron Technical
(800) 523-9466.
Support Center at
12
RadioTouch
Setup Guide for RTA-RS232
TM
Controller.
TM
P/N 500-9258 Rev A
Controller.
TM
P/N 500-9258 Rev A
Step D:Go to the RadioTouch
add to the RS232 Interface zone. Press and
release the programming button on the
Controller. After the button is pressed the
lights will cycle up and down for 3 seconds to
notify you that you are in programming mode,
and settle at 50% light output. If you are using
an RTA-RX-SW the lights will cycle OFF and
ON. The Status LED on the Controller will be
in fast blink mode. If no lights are connected to
this Controller, the status LED will be your only
feedback.
1 2 3
4
5
6 7
8
Occ. Sensor
0-10 V
Class 2 wiring connections shown above.
Power Status Program
1 2 3 4 5
1
2
3
4
5
6
7
8
CLASS 2 LOW VOLTAGE WIRING
RadioTouch
Controller
TM
Controller you wish to
TM
Burn-In
Advertisement
Chapters
Table of Contents
