Delayed Start Or Stop; Programming In Manual Mode; Programming In Auto Mode; Service Mode - Seeley LCQ Owner's Manual

MAGIQCOOL CONTROLLER
OPERATION cont

Delayed Start or Stop

The cooler can be programmed to start at a
specific time or stop at a specific time.
The delayed start time can only be
programmed when the cooler is OFF. To
program the cooler to start in a certain amount
of hours use the following sequence:

Programming In Manual Mode

(1)...... Press the
(2)...... Press the
displayed on the screen.
(3)...... Press the
until the desired fan speed is displayed by the
bars in the middle of the screen.
(4)...... Press the
COOL or VENT.
(5)...... Press the
in' time will start flashing.
Use the and
the desired time.
(6)...... Press

Programming In Auto Mode

(1)...... Press the
(2)...... Press the
displayed.
(3)...... Press the
in' time will start flashing.
Use the or
the hour.
(4)...... Press again.
The delayed stop time can only be
programmed once the cooler is ON.
button.
button until MAN is
or button
ILL1118-A
button to set either
button and the 'starts
buttons to select
again.
button.
button until AUTO is
button and the 'starts
button to select
ILL1117-B
LCQ / LCS / LCQI / LPQI / BMQ / CPQ / TBQ / TBS / TBQI / TBSI OWNER'S MANUAL |
This is ideal if you are going to bed but don't
want to turn the cooler off straight away. To
program the delayed time in which you want
the cooler to stop use the following sequence:
(1)......Select the
in' time will start flashing.
Use the and
the desired off time.
(2)......Press again.

Service Mode

When a fault has been recognised by the wall
control the word "Service" flashes on the
screen.
When "Service" is displayed it may be
necessary for you to phone the service number
located near the back of this manual. However,
before doing so, turn the wall control OFF. You
will notice a number flashing at the bottom of
the screen. This number indicates the reason
for requiring service.
Please write this number down, then push
the button to turn the cooler back on.
If after a short time "Service" is again shown
on the display, turn the wall control OFF and
check if the flashing number is the same. If it
is the same check for the following possible
problems.
However, we do recommend that any checks
be carried out by an authorised dealer or
service agent.
button and the 'stops
buttons to select
ILL1119-B
ILL1120-B
ILL1121-B
3