Osd-On Screen Display - Christie D4K40-RGB Technical Reference

Command
NET+DHCP 1
NET+ETH0?
NET+GATE?
NET+HOST "<name>"
NET+MAC0?
NET+PORT?
NET+SUB0?
NET+SWIT <value>
Examples
Set the static IP address to 192.168.1.100, with a netmask of 255.255.255.0, and no gateway:
(NET "192.168.1.100" "255.255.255.0")
Turn on DHCP support:
(NET+DHCP 1)
OSD–On Screen Display
Displays or hides the on-screen display.
Commands
Command Description
OSD? Returns the status of the on-screen display.
(Read-only)
OSD <0 | 1> Enables or disables the on-screen display.
D4K40-RGB Technical Reference–Serial Commands
020-102972-02 Rev. 1 (01-2019)
Copyright 2019 Christie Digital Systems USA, Inc. All rights reserved.
©
Description
Enables DHCP. To turn off DHCP support, switch to a
static IP by using the base command. (Saved value)
Returns the projector IP address. (Read-only)
Returns the projector gateway address. (Read-only)
Sets the name for the projector. With this set, devices
on the same network subnet as the projector can
connect to it using the name: <name>.local. (Saved
value)
Returns the MAC address of the Ethernet port. (Read-
only)
Returns the TCP port used for the Christie serial
protocol over Ethernet. (Read-only)
Returns the projector netmask. (Read-only)
Sets the internal network switching mode.
Serial API commands
Values
1
—
—
name = Name for the
projector
—
1024 to 49151 (with some
exceptions)
3003 = Reserved on the
projector and cannot be
used for the Christie serial
protocol
—
0 = Split (Default)
1 = All ports joined
2 = HDBaseT joined with
Ethernet (for network
loop-through)
Values
—
0 = Hides the on-screen display
1 = Displays the on-screen display
44