Ken-Keypad Enable - Christie D4K40-RGB Technical Reference

Command Description
ITP+GRDP <pitch> Defines the spacing between lines used for the Square
Grid and Diagonal Grid test patterns.
This command is only available if video electronics are
on.
ITP+GREY <grey Defines the shade of grey for the Flat Grey test pattern.
level>
This command is only available if video electronics are
on.
ITP+RMPL <grey Defines the starting (top/left) grey-level used for the
level> Horizontal Ramp, Vertical Ramp, and Diagonal Ramp
test patterns.
This setting has no effect when the ramp is moving
(such as ITP+RMPM is non-zero).
This command is only available if video electronics are
on.
ITP+RMPM <speed> Defines the motion speed used for the Horizontal Ramp,
Vertical Ramp, and Diagonal Ramp test patterns.
This command is only available if video electronics are
on.
ITP+RMPS <slope> Defines the slope used for the Horizontal Ramp, Vertical
Ramp, and Diagonal Ramp test patterns.
This command is only available if video electronics are
on.
Examples
Disable test patterns:
(ITP 0)
Set the test pattern to the grid pattern:
(ITP 1)
Enable a moving grid test pattern:
(ITP+GRDM 1)
KEN–Keypad Enable
Enables or disables the IR or wired keypad sensors.
Commands
Command Description
KEN+FRNT <0 | 1> Enables or disables the IR keypad sensor.
(Saved value)
D4K40-RGB Technical Reference–Serial Commands
020-102972-02 Rev. 1 (01-2019)
Copyright 2019 Christie Digital Systems USA, Inc. All rights reserved.
©
Serial API commands
Values
2 to 127
32 (Default)
0 to 4095
2048 (Default)
0 to 4095
0 (Default)
0 to 100
0 (Default)
1 to 5
1 (Default)
Values
0 = Disables the front IR keypad sensor
1 = Enables the front IR keypad sensor
(Default)
36