Download
Share
Print this page
  1. Manuals
  2. Brands
  3. Christie Manuals
  4. Projector Accessories
  5. Dual LOS
  6. Installation instructions manual

Christie Dual LOS Installation Instructions Manual

Hide thumbs

Advertisement

Quick Links

Download this manual
Installing the Dual LOS
pedestal
These instructions provide steps to safely install a CP4440-RGB, CP4445-RGB, CP4450-RGB, or
CP4455-RGB projector onto the pedestal. This pedestal is designed to safely hold the projectors at an
adequate height for most projection rooms.
Affected products
The Christie Pedestal kit is only intended for use with the following Christie projector models:
•
CP4440-RGB
•
CP4445-RGB
•
CP4450-RGB
•
CP4455-RGB
Required tools
The following tools are required.
•
#3 Phillips screwdriver
•
5 mm flathead screwdriver
•
2.5 mm hex driver
•
3 mm hex driver
•
4 mm hex driver
•
5 mm hex driver
•
24 mm wrench
•
Tape measure
•
Level
Prerequisites
The following components are required.
•
Christie Pedestal kit (P/N: 163-126100-XX)
Installing the Dual LOS Pedestal Instruction Sheet
020-103141-03 Rev. 1 (01-2023)
Copyright
©
2023 Christie Digital Systems USA, Inc. All rights reserved.
If printed, please recycle this document after use.
1

Advertisement

loading

Related Manuals for Christie Dual LOS

Summary of Contents for Christie Dual LOS

  • Page 1 CP4455-RGB projector onto the pedestal. This pedestal is designed to safely hold the projectors at an adequate height for most projection rooms. Affected products The Christie Pedestal kit is only intended for use with the following Christie projector models: • CP4440-RGB •...

  • Page 2: Safety Precautions

    Installing the Dual LOS pedestal Safety precautions Learn about the safety precautions related to the Dual LOS pedestal. Warning! If not avoided, the following could result in death or serious injury. • A minimum of four people or appropriately rated lift equipment is required to safely lift or move the pedestal or projector.
  • Page 3 6. Adjust the leveling feet to the floor surface, so the top pedestal surface is level. 7. Tighten the pedestal leveling feet jam nuts. Installing the Dual LOS Pedestal Instruction Sheet 020-103141-03 Rev. 1 (01-2023) Copyright © 2023 Christie Digital Systems USA, Inc. All rights reserved. If printed, please recycle this document after use.
  • Page 4 The top two holes (illustrated in the image below) are used for the maximum leg extension, which is required to achieve 15 degrees. Installing the Dual LOS Pedestal Instruction Sheet 020-103141-03 Rev. 1 (01-2023) Copyright © 2023 Christie Digital Systems USA, Inc. All rights reserved. If printed, please recycle this document after use.
  • Page 5 Front foot lock bracket (1 of 2) Rear foot lock bracket (1 of 2) Installing the Dual LOS Pedestal Instruction Sheet 020-103141-03 Rev. 1 (01-2023) Copyright © 2023 Christie Digital Systems USA, Inc. All rights reserved. If printed, please recycle this document after use.
  • Page 6 8. Install and lock the bracket covers onto the foot brackets with the four M5 screws. Installing the Dual LOS Pedestal Instruction Sheet 020-103141-03 Rev. 1 (01-2023) Copyright © 2023 Christie Digital Systems USA, Inc. All rights reserved. If printed, please recycle this document after use.
  • Page 7 Installing the Dual LOS pedestal Installing the Dual LOS Pedestal Instruction Sheet 020-103141-03 Rev. 1 (01-2023) Copyright © 2023 Christie Digital Systems USA, Inc. All rights reserved. If printed, please recycle this document after use.

  • Page 8: Installing External Devices

    (C in the image above) located at the bottom front of the stand. Installing the Dual LOS Pedestal Instruction Sheet 020-103141-03 Rev. 1 (01-2023) Copyright © 2023 Christie Digital Systems USA, Inc. All rights reserved. If printed, please recycle this document after use.
  • Page 9 1. Unlock the side panels using the provided key. 2. Remove both side panels as shown. Installing the Dual LOS Pedestal Instruction Sheet 020-103141-03 Rev. 1 (01-2023) Copyright © 2023 Christie Digital Systems USA, Inc. All rights reserved. If printed, please recycle this document after use.
  • Page 10 1. Place a foot lock bracket over each leveling foot. 2. Secure each bracket to the floor. Installing the Dual LOS Pedestal Instruction Sheet 020-103141-03 Rev. 1 (01-2023) Copyright © 2023 Christie Digital Systems USA, Inc. All rights reserved. If printed, please recycle this document after use.

  • Page 11: Pedestal Dimensions

    Use the CP4440-RGB and CP4450-RGB Line Drawing (P/N: 020-103101-XX) or the CP4445-RGB and CP4455-RGB Line Drawing (P/N: 020-103762-XX) to plan the installation location of the pedestal. Technical support Technical support for Christie Cinema products is available at: • Support.cinema@christiedigital.com •...