Lho-Lens Horizontal Position Adjustment; Lmv-Lens Move - Christie D4K40-RGB Technical Reference

Command Description
LCB+ZOOM 1 Calibrates the zoom motor.
Examples
Start calibration:
(LCB 1)
Move the lens back to the home position:
(LCB+HOME)
LHO–Lens Horizontal Position Adjustment
Sets the lens horizontal location to an absolute position.
This command is only available when the projector is on.
Commands
Command Description
LHO?m Returns the minimum and maximum range of the zoom axis
based on the last lens calibration performed. The returned
range is persistent across AC cycles. (Read-only)
LHO Adjusts the horizontal location of the lens to the specified
<position> position. The position is persistent across AC cycles.
Examples
Move the lens to position 500 on the horizontal axis:
(LHO 500)
LMV–Lens Move
Adjusts all aspects of the lens position using a single command.
Commands
Command
LMV <horizontal> <vertical>
<zoom> <focus>
D4K40-RGB Technical Reference–Serial Commands
020-102972-02 Rev. 1 (01-2019)
Copyright 2019 Christie Digital Systems USA, Inc. All rights reserved.
©
Description
Moves the lens to an absolute
position as specified by each of
the four arguments.
Serial API commands
Values
1 = Lens has a zoom motor
1
Values
—
position = Numeric value subject
to the range returned in LHO?m
Values
Minimum and maximum of each axis =
Dependent on the projector and the
installed lens
Maximum horizontal range = -1600 to 1600
39