Lcb-Lens Motor Calibration - Christie D4K40-RGB Technical Reference

Command Description
LAS+GRNP <value> Changes the green laser drive level.
LAS+MAXA <value> Sets the expected maximum ambient
temperature in Celsius.
LAS+MODE <0 | 1> Enables or disables LiteLOC.
LAS+REDP <value> Changes the red laser drive level.
Examples
Enable LiteLOC:
(LAS+MODE 0)
Disable the green laser:
(LAS+EGRN 0)
Change the red laser drive level to 100%:
(LAS+REDP 1000)
Return the color sensor Z reading:
(LAS+CSRZ?)
Set the expected maximum ambient temperature to 25°C:
(LAS+MAXA 25)
LCB–Lens Motor Calibration
Calibrates all of the lens motors.
This command is only enabled when the projector is on.
Commands
Command Description
LCB 1 Runs calibration on all lens motors.
LCB+HOME Moves all lens motors back to the center flag for each
axis and sets their respective positions to 0.
LCB+LOCK <0 | 1> Locks all lens motors preventing the lens from moving.
This overrides all other lens functions.
LCB+ZOMR <0 | 1> Programs the lens connector board lens (LCBL) to
indicate that the lens is motorized or non-motorized.
D4K40-RGB Technical Reference–Serial Commands
020-102972-02 Rev. 1 (01-2019)
Copyright 2019 Christie Digital Systems USA, Inc. All rights reserved.
©
Serial API commands
Values
1 = Enables the red laser (Default)
0 to 1000, where 1000 = 100% drive level
615 (Default)
0 to 50
35 (Default)
0 = Enables LiteLOC
1 = Disables LiteLOC (Default)
0 to 1000, where 1000 = 100% drive level
820 (Default)
Values
1
—
0 = Unlocks motors (Default)
1 = Locks motors
0 = Lens does not have a zoom
(Default)
38