Interface Options - IET Labs, Inc. RLC Digibridge 1693 User And Service Manual

5.5.3 Interface Options

If the Digibridge has the IEEE interface option, it
can be connected via either the RS232 interface or
the IEEE 488.2 interface.
Figure 5-7: IEEE interface (1689-9640), front
view
Figure 5-8: IEEE interface (1689-9640), top view
Service and Maintenance
Figure 5-5: Keyboard Assembly (1687-4200)
Figure 5-6: Power Supply Assembly (700011)
To remove the IEEE board:
1. Switch POWER OFF and disconnect power
cord from Digibridge.
2. Place the instrument in the normal position
(flat on table or in rack). Looking at the rear
panel, remove the two screws that hold the
interface from the Digibridge. See Figure
5-9 below.
Note: if the IEEE option is not installed, there will be a
blank plate to cover the opening.
1693 RLC Digibridge
121