Table of Contents
Advertisement
General safety information
Safety Summary
The following general safety precautions must be
observed during all phases of operation, service
and repair of this instrument. Failure to comply
with these precautions or specific WARNINGS
given elsewhere in this manual will violate safety
standards of the design, manufacturing, and
intended use of the instrument. IET Labs. assumes
no liability for the customer's failure to comply with
these requirements.
Before Applying Power
Verify that the power is set to match the rated input
of this instrument.
Protective Ground
Make sure to connect the protective ground to
prevent an electric shock before turning on the
power.
Necessity of Protective Grounding
Never cut off the internal or external protective
ground wire, or disconnect the wiring of the
protective grounding terminal. Cutting the
protective ground could cause a potential shock
hazard and result in injury to a person.
Fuses
Only fuses with the required rated current, voltage
and specified type (normal blow, time delay, etc.)
should be used. Do not use repaired fuses or short-
circuited fuse holders. Using the wrong fuse could
cause a shock or fire hazard.
Safety Information
SAFETY
INFORMATION
Do not operate in an explosive atmosphere
Do not operate this instrument in the presence of
flammable gases or fumes.
Do not remove the cover of the instrument
Operating personnel must not remove the cover
of this instrument. Component replacements and
internal adjustments can be done only by qualified
service personnel. Dangerous voltages may be
present inside this instrument. Do not open the case
Refer servicing to qualified personnel.
Disposal
Do not dispose of electrical appliances as unsorted
municipal waste, use separate collection facilities.
Contact your local government for information
regarding the collection systems available. If
electrical appliances are disposed of in landfills
or dumps, hazardous substances can leak into the
groundwater and get into the food chain, damaging
your health and well-being. When replacing old
appliances with new one, the retailer is legally
obligated to take back your old appliances for
disposal.
1693 RLC Digibridge
xi
Advertisement
Table of Contents
