IET Labs, Inc. RLC Digibridge 1693 User And Service Manual page 142

1693 RLC Digibridge
is attached (via a short piece of rubber tubing) to the
power switch. Guide the front end of this rod through
its hole in the bezel while bringing the front panel as-
sembly into position. (The bottom access panel should
be out of the way during this procedure.)
13
12
11
118
1
10
Figure 5-2: Interior top view of 1693 Digibridge
Item
1 Power Supply
2 Regulator Board
3 ac power connector
4 Cable connecting Power Supply to Power Switch
5 Ribbon cable connecting Regulator Board to Main Board
6 Analog and Control board
7 Shield Plate
8 Keyboard assembly
9 Cables connecting Main Board to Keyboard
10 Ribbon cables connecting Main Board to Display Panel
11 bnc Bracket assembly
12 Display board assembly
13 Retainer brackets for cable connectors
Notice also that (if the BNC connector bracket is at
the front) its shielded cables must be kept to the left of
the display-panel connector board during reassembly
(to avoid pinching the cables).
2
9
Description
3
4
5
6
7
8
Service and Maintenance