Ieee 488.2 / Scpi Digibridge Command Reference - IET Labs, Inc. RLC Digibridge 1693 User And Service Manual

1693 RLC Digibridge
3.11.10 IEEE 488.2 / SCPI Digibridge
Command Reference
Note: Parameters in italic are available only on the
Digibridge 1693-9700 model.
:CONFigure:PARameter
Syntax:
:CONFigure:PARameter {LQ|CD|CR|RQ|
LQPPm|CDPPm|CRPPm|RQPPm|AUTo|
RX|GB|ZANG|YANG|ZAPPm|YAPPm}
Description:
Sets the measured parameter.
Parameter:
Value
LQ Inductance (L/Q)
CD Capacitance (C/D)
CR Capacitance (C/R)
RQ Resistance (R/Q)
LQPPm Inductance (L/Q) ppm
CDPPm Capacitance (C/D) ppm
CRPPm Capacitance (C/R) ppm
RQPPm Resistance (R/Q) ppm
AUTo (default) Automatic selection of R/Q, C/D, or L/Q
RX Resistance (R/X)
GB Conductance (G/B)
ZANG Impedance (Z/ANG)
YANG Admittance (Y/ANG)
ZAPPm Impedance (Z/ANG) ppm
YAPPm Admittance (Y/ANG) ppm
Equivalent legacy command:
M0, M1, M2, M3, M4, M5, M6, M7, M8, K2, K3,
K4, K5, K6, K7
Equivalent key:
select appropriate parameter key(s)
:CONFigure:CIRCuit
Syntax:
:CONFigure:CIRCuit {PARallel|SERies}
Description:
Sets the measurement equivalent circuit.
80
Description
Parameter:
Value
PARallel Parallel equivalent circuit
SERies Series equivalent circuit
Equivalent legacy command:
C0, C1
Equivalent key:
[EQUIVALENT CIRCUIT]
:CONFigure:APERture
Syntax:
:CONFigure:APERture {FAST|MEDium|SLOW }
Description:
Sets the measure rate.
Parameter:
Value
FAST Sets measurement rate to fast
MEDium Sets measurement rate to medium
SLOW Sets measurement rate to slow
Equivalent legacy command:
S0, S1, S2
Equivalent key:
[MEASURE RATE]
:CONFigure:MODe
Syntax:
:CONFigure:MODe {TRIGgered|CONTinuous|M
TRiggered|MCONtinuaous}
Description:
Sets the measure mode.
Parameter:
Value
TRIGgered Set measurement mode to triggered
Continuous Set measurement mode to continuous
MTRiggered Set measurement mode to triggered median value
Set measurement mode to continuous median
MCONtinuous
value
Equivalent legacy command:
T0, T1, T2, T3
Description
Description
Description
Operation