IET Labs, Inc. RLC Digibridge 1693 User And Service Manual page 110

1693 RLC Digibridge
Parameter:
Value
DISable Disable
OPEN Enable open circuit calibration
SHORt Enable short circuit calibration
Equivalent legacy command:
Z0, Z1, Z2
Equivalent key:
[1693] [=] [SHIFT] [OPEN]
[1693] [=] [SHIFT] [SHORT]
:SYSTem:COMMunicate:GPIB:ADDRess?
Syntax:
:SYSTem:COMMunicate:GPIB:ADDRess
Description:
Reads the GPIB address of the Digibridge. (Query
Only) The GPIB address can only be changed
by changing the SW2 DIP switch setting on the
Digibridge IEEE.2 Communication board.
Parameter:
Value
1 to 30 Numeric value range
3 (default) Default GPIB address
Equivalent legacy command:
none
Equivalent key:
none
:SYSTem:COMMunicate:GPIB:CONFigure
Syntax:
:SYSTem:COMMunicate:GPIB:CONFigure
{ENABle|DISable}
Description:
Enable or disable the GPIB interface. The GPIB in-
terface can be disabled to prevent interference with
or slowing down of measurements if using another
interface, such as the RS-232 serial interface, for
communicating with the Digibridge instrument.
86
Description
Description
Parameter:
Value
ENABle Enable GPIB interface.
DISable Disable GPIB interface (if using RS-232).
Equivalent legacy command:
none
Equivalent key:
none
:SYSTem:COMMunicate:SERial:CONFigure
Syntax:
:SYSTem:COMMunicate:SERial:CONFigure
{ENABle|DISable}
Description:
Enable or disable the RS-232 serial interface. The
RS-232 serial interface can be disabled to prevent
interference with or slowing down of measure-
ments if using another interface for communicating
with the Digibridge instrument.
Parameter:
Value
ENABle Enable RS-232 serial interface.
DISable Disable RS-232 serial interface.
Equivalent legacy command:
none
Equivalent key:
none
:SYSTem:COMMunicate:SERial:BAUDrate
Syntax:
:SYSTem:COMMunicate:SERial:BAUDrate
{9600|19200|38400|57600|115200}
Description:
Set the RS-232 serial interface baud rate.
Description
Description
Operation