Mounting The Slotted Disc (Optical Speed Measuring System) - HBM T10FS Operating Manual

24
4.7 Mounting the slotted disc (optical speed measuring
system)
To prevent the slotted disc of the optical speed measuring system being
damaged in transit, it is not mounted on the rotor in the case of measurement
flanges with option 2, code L (nominal (rated) speed 8000 min
-1
15000 min ). Before installing the rotor, it must be attached in the shaft train.
The associated speed sensor is already mounted on the stator.
The requisite screws, a suitable screwdriver and the screw locking device are
included in the list of components supplied.
Slotted disc
Fig. 4.7: Mounting the slotted disc on the rotor
IMPORTANT
At all stages of the mounting operation, be careful not to damage the
slotted disc!
Mounting sequence
Push the slotted disc onto the rotor and align the screw holes.
Apply some of the screw locking device to the screw thread and tighten the
screws (tightening torque < 15 Ncm).
HBM
T10FS
-1
to
A0785-1.4 en