Application - HBM T10FS Operating Manual

T10FS
2

Application

T10FS torque flanges record static and dynamic torque on fixed or rotating
shafts and also return RS-422 signals with direction of rotation information to
determine the speed. With an optical speed measuring system, a reference
pulse can also be output with the speed pulses. Test beds can be extremely
compact because of the short construction of the measurement flanges. They
offer a very wide range of applications.
In addition to conventional test‐bench engineering (engine, roll and
transmission test benches), new solutions are possible for torque
measurements partly integrated in the machines. Here, you benefit in full from
the T10FS torque flange special characteristics:
 low rotor weights
 low mass moments of inertia
 small outside diameters
 no bearings, no slip rings
Thanks to the bearing‐free design and the contactless transmission of
excitation voltage and measured values, there are no friction or bearing
heating effects.
Torque flanges are supplied for nominal (rated) torques from 100 Nm to
10 kNm. Depending on the nominal (rated) torque, maximum speeds of up to
-1
24 000 min are permissible.
T10FS torque flanges are reliably protected against electromagnetic
interference. They have been tested with regard to EMC according to the
relevant European standards, and carry the CE mark.
A0785-1.4 en
11
HBM