Fixing The Mounting Elements; Mounting The Torque Flange With A Speed Measuring System - HBM T10FS Operating Manual

26

4.8.1 Fixing the mounting elements

1. Place the rotor with the identification plate upward on a flat base.
For the optical speed measuring system only:
Hold the stator at a slight slant and push it over the rotor until the slotted disc
is located in the optical sensor (Step A, Fig. 4.9).
Tilt the stator over the rotor until the antenna ring completely covers the
transformer (Step B, Fig. 4.9).
B
Transformer
Slotted disc
Fig. 4.9: Installing the mounting elements
2. Hold the stator centrally over the rotor and one after the other, push the
three mounting elements between the transformer and the antenna ring.
The mounting elements should be evenly distributed around the
circumference (approx. every 120_).
3. Screw the fastening screws of the mounting elements into the tapped
holes of the flange and gently tighten them by hand.

4.8.2 Mounting the torque flange with a speed measuring system

1. Mount the torque flange in the shaft train so that the bearing surface of the
stator base lies on the prepared mounting surface free from play and
stress.
2. Fasten the rotor with 8 screws in the shaft train (for the property class, see
Tab. 4.1, Page 19). Initially, the screws should only be hand‐tight.
3. Compensate for any possible misalignment of the stator by putting
adjusting washers underneath or by adjusting the base.
HBM
Antenna ring
A
Sensor pickup
T10FS
A0785-1.4 en