Chapter 4
Mounted Boom Sensor
FIGURE 2.
Locate the left and right ultrasonic sensors (P/N 063-0130-012 and 063-0130-014) in the AutoBoom
1.
installation kit.
Remove the sensor from the existing plastic arm.
2.
Install the sensors on the 12" S-type sensor arms (P/N 063-0131-592) using the supplied 5/16"-18 x 1-1/4"
3.
bolts (P/N 311-0052-106), 5/16"-18 nylon insert lock nuts (P/N 312-4000-059) and 5/16" zinc flat washers
(P/N 313-2300-012).
Secure the left sensor (P/N 063-0130-014) to the front of the left boom using two 1-9/16" W x 2-1/2" L x 3/8"
4.
thread U-bolts (P/N 107-0171-611) and four 3/8"-16 zinc flanged lock nuts (P/N 312-1001-164).
Tighten the nuts to ensure the sensor is mounted securely.
5.
Repeat the steps above to mount the remaining boom sensor(s).
6.
Install the Center Rack Sensor
Center Sensor Mounted to the Bracket
FIGURE 3.
Secure the center sensor (P/N 063-0130-018) to the ultrasonic sensor boom mount weldment (P/N 116-
1.
0159-684) using four 3/8"-16 UNC x 1-1/4" hex bolts (P/N 311-0054-106) and four 3/8"-16 zinc flanged lock
nuts (P/N 312-1001-164).
20
MS Condor T-1000 with Hystar Valve AutoBoom Installation Manual