Connect The Harness Cable To The Boom Function Controls - Raven AutoBoom Installation Manual

Chapter 5
Mount the AutoBoom node (P/N 063-0130-013) to the AutoBoom valve mounting plate using three 3/8"-16
1.
UNC x 1-1/4" hex bolts (P/N 311-0054-106) and three 3/8"-16 zinc flanged lock nuts (P/N 312-1001-164).
Note:
Install the AutoBoom node so that the cable connectors face to the side.
Insert the large, rectangular node connectors on the harness cable (P/N 115-0230-045 or 115-0230-085)
2.
into the correct ports of the AutoBoom valve.
Tighten the bolts on the node connectors to secure the connections.
3.
Connect the Harness Cable to the Boom
Function Controls
Locate the Left Press and Right Press connectors on the harness cable (P/N 115-0230-045 or 115-0230-
1.
085).
Route the connectors to the AutoBoom valve (P/N 063-0131-126).
2.
Connect the Left Press connector to Port G1 on the AutoBoom valve.
3.
Connect the Right Press connector to Port G4 on the AutoBoom valve.
4.
Locate the Left Solenoid and Right Solenoid connectors on the harness cable.
5.
Connect the Left Solenoid connector to Port 4A on the AutoBoom valve.
6.
Connect the Right Solenoid connector to Port 4B on the AutoBoom valve.
7.
Locate the Left Prop and Right Prop connectors on the harness cable.
8.
Connect the Left Prop connector to Port 5A on the AutoBoom valve.
9.
Connect the Right Prop connector to Port 13A on the AutoBoom valve.
10.
Boom Sense Adapter Cables Installed
FIGURE 2.
Note:
The splice connectors contained in the installation kit may vary slightly from the image above.
However, the connections contained in the instructions below remain the same.
Cut the ring terminal ends off the boom sense adapter cable (P/N 115-0230-001)
11.
Locate the machine's boom function coils near the machine's hydraulic valve.
12.
Locate the left tilt up coil using a test light or multi-meter to detect voltage on the din connector when the left
13.
up switch is pressed in the cab.
24 MS Condor T-1000 with Hystar Valve AutoBoom Installation Manual