Mount The Center Rack Sensor; Connect The Sensor Cables - Raven AutoBoom Installation Manual

New holland guardian f/miller nitro n7 series with mono boom

Hide thumbs Also See for AutoBoom:

Table of Contents

HAPTER

MOUNT THE CENTER RACK SENSOR

FIGURE 5. Center Rack Sensor Mounting

1. Install one 5/16" flat washer (P/N 313-2300-012) on the end of one 5/16"-18 x 1-1/4" hex bolt (P/N 311-0052-

106).

2. Align the hole in the sensor with the hole on the narrow end of the machine's existing sensor extension bracket.

3. Insert the bolt and washer through the aligned holes in the sensor and bracket.

4. Install another 5/16" flat washer (P/N 313-2300-012) on the end of the installed hex bolt and secure it using one

5/16"-18 nylon insert lock nut (P/N 312-4000-059).

5. Mount the sensor bracket to the front-right side of the machine's center rack using two 3/8"-16 UNC x 1" hex

bolts (P/N 311-0054-105) and two 3/8"-16 zinc flanged lock nuts (P/N 312-1001-164) as shown in Figure 4 above.

6. Tighten the nut to ensure the sensor is mounted securely.

1. Connect the left sensor cable (P/N 115-0230-051) to the connector on the left sensor.

2. Route the left sensor cable toward the AutoBoom valve.

3. Loop and tie-off any excess cable, allowing enough cable for boom folding and extension.

4. Repeat the steps above to connect the remaining sensor cable(s).

NOTE:

The sensor cables will be connected to the AutoBoom system in the wiring phase of installation.

New Holland Guardian F/Miller Nitro N7 Series with Mono Boom AutoBoom® Installation Manual

Table of Contents