C
5
HAPTER
1. Secure the left sensor (P/N 063-0130-014) to the front of the left boom using two 2" W x 4" L x 3/8" thread U-
bolts (P/N 321-0000-363) and four 3/8"-16 zinc flanged lock nuts (P/N 312-1001-164).
2. Tighten the nuts to ensure the sensor is mounted securely.
3. Repeat the steps above to mount the remaining boom sensor(s).
MOUNT THE CENTER RACK SENSOR
FIGURE 8. Mounted Center Rack Sensor
1. Secure the center sensor (P/N 063-0130-018) to the center sensor mounting bracket (P/N 107-0172-148) using
two 3/8"-16 UNC x 1-1/4" hex bolts (P/N 311-0054-106) and two 3/8"-16 zinc flanged lock nuts (P/N 312-1001-
164).
2. Mount the center sensor and bracket to the machine's center rack using two 3" W x 6" L x 3/8" thread U-bolts
(P/N 107-0171-959) and four 3/8"-16 zinc flanged lock nuts (P/N 312-1001-164).
3. Tighten the nuts to ensure the sensor is mounted securely.
CONNECT THE SENSOR CABLES
1. Connect the left sensor cable (P/N 115-0171-527) to the connector on the left sensor.
2. Route the left sensor cable toward the AutoBoom valve.
3. Loop and tie-off any excess cable, allowing enough excess cable for boom folding and extension.
4. Repeat the steps above to connect the remaining sensor cables.
NOTE:
The sensor cables will be connected to the AutoBoom system in the wiring phase of installation.
INSTALL THE GAUGE WHEELS - OPTIONAL
GAUGE WHEEL MOUNTING LOCATIONS
Wheel mounting locations may be influenced by the boom configuration. Determine the appropriate location for
mounting the wheels on the boom, ensuring the wheels will not interfere with or be damaged while folding or
48
Top Air AutoBoom Installation Manual