Mount The Center Rack Sensor; Connect The Sensor Cables - Raven AutoBoom Installation Manual

Chapter 4

Mount the Center Rack Sensor

Mounted Center Rack Sensor
FIGURE 6.
Mount the center sensor to the machine's center rack using two 1-9/16" W x 2-1/2" L x 3/8" thread U-bolts
1.
(P/N 107-0171-611) and four 3/8"-16 zinc flanged lock nuts (P/N 312-1001-164).
Tighten the nuts to ensure the sensor is mounted securely.
2.

Connect the Sensor Cables

Connect the left sensor cable (P/N 115-0171-527) to the connector on the outer left sensor.
1.
Route the left sensor cable toward the AutoBoom valve.
2.
Loop and tie-off any excess cabling, allowing enough cable for boom folding and extension.
3.
Repeat the steps above to connect the remaining sensor cable(s).
4.
Note:
The sensor cables will be connected to the AutoBoom system in the wiring phase of installation.
36 GVM Predator (2007 & Older) AutoBoom Installation Manual