Mount The Center Rack Sensor - Raven AutoBoom Installation Manual

Locate the left and right ultrasonic sensors (P/N 063-0130-012 and 063-0130-014) in the AutoBoom
1.
installation kit.
Remove the sensor from the existing plastic arm.
2.
Install the sensors on the 12" S-type sensor arms (P/N 063-0131-592) using the supplied 5/16"-18 x 1-1/4"
3.
bolts (P/N 311-0052-106), 5/16"-18 nylon insert lock nuts (P/N 312-4000-059) and 5/16" zinc flat washers
(P/N 313-2300-012).
Secure the left sensor (P/N 063-0130-014) to the front of the left boom using two 2-1/16" W x 3" L x 3/8"
4.
thread U-bolts (P/N 107-0171-609) and four 3/8"-16 zinc flanged lock nuts (P/N 312-1001-164).
Tighten the nuts to ensure the sensor is mounted securely.
5.
Repeat the steps above to install the remaining boom sensor(s).
6.

Mount the Center Rack Sensor

Center Sensor Mounted to the Bracket
FIGURE 8.
Install the center sensor (P/N 063-0130-018) on the ultrasonic sensor boom mount weldment bracket (P/N
1.
116-0159-684) using four 3/8"-16 UNC x 1-1/4" hex bolts (P/N 311-0054-106) and four 3/8"-16 zinc flanged
lock nuts (P/N 312-1001-164).
Mounted Center Rack Sensor
FIGURE 9.
Mount the center sensor to the cross-beam of the machine's center rack using two 2-9/16" W x 2-1/2" L x
1.
3/8" thread U-bolts (P/N 107-0171-616) and four 3/8"-16 zinc flanged lock nuts (P/N 312-1001-164).
Tighten the nuts to ensure the sensor is mounted securely.
2.
Manual No. 016-0230-095 Rev. D
UltraGlide
37