Beam - Replacement Of Short Pivot Arm - Braillo 650 SW2.1 User Manual

BRAILLO B 650 SW2.1
l

5.13 Beam - replacement of short pivot arm

See the figures below:
Remove the six screws as
indicated in the figure.
Pull out the short pivot
arms, there are 45 pcs. on
each side.
Pull out the shaft, and
replace the short pivot
arm(s).
Assembly is done in re-
verse order.
Note! When putting the short pivot arms back into the beam, be sure that the printing pins are hang-
ing vertically like in the figure. This is to make room for the short pivot arm.
98