Power On - Braillo 650 SW2.1 User Manual

BRAILLO
l

2.10 Power on

The On/Off switch is placed on the printer, behind the back panel and can be reached through an
opening in the panel. When the mains cable has been connected, and the power has been switched
on, the printer will do it's start up sequence. The display will stay black for a moment, then it will
show a progress bar for the start up sequence. When it's done, the display will show "Welcome, press
the accept button to continue". Press the button and the display will change to "Ready to emboss".
For safety reasons, there are mechanical switches on the printer cover. These switches will
disable the possibility to run the printer if the side plates are removed.
The paper feed unit will move a little back and forth to find the home position. If there is no paper
inserted, the printer will start an alarm, and the display reads "Printer halted - Out of paper". This is
normal, and the sound can be silenced by pressing the mute button.
Note that the printer will go into sleep mode when it has been inactive for 15 minutes. If that hap-
pens, the printer will wake up if you touch the operating panel or send a file from the computer. It is
also possible to manually put it in sleep mode by entering the main menu, and select the "Enter sleep
mode" choice.
The printer is now ready. Before continuing, please read chapter 4 'OPERATING THE PRINTER' on page
38 carefully.
On/Off switch
26
B 650 SW2.1