Braillo 650 SW2.1 User Manual page 41

BRAILLO B 650 SW2.1
l
Stacker, adjust width and end stop
When adjusting the position of the trap doors, make sure that they are aligned with the paper coming
out from the printer. Loosen the four knobs on the top, and then turn the knob at the end to move
the trap door units sideways. The end stop can be adjusted by loosening the two knobs and push it
back and forth.
Adjust to paper width + e.g. 2 mm
1. Loosen these four knobs
2. Adjust with this knob
Adjust to sheet length
41