Braillo 650 SW2.1 User Manual page 63

BRAILLO B 650 SW2.1
l
- Beam wheel failure
This means that the pulses from the Beam wheel sensor is not reg-
istered in the electronics. This can be caused by e.g. defect sensor,
disconnected sensor, broken main belt, or defect main motor. If you
can hear the main motor start, it is probably something wrong with
the sensor. But if you cannot hear the motor start, it is probably some-
thing wrong with the main motor. Press Reset to continue. The sensor
can be tested manually on
Main Menu - Warning - Service/diagnostic - Test Sensors.
- Page self adj. failure
The printer has detected position problems with the paper feeding on
e.g. power up or resetting. Could be caused by e.g. a defect/discon-
nected sensor or stepping motor. The sensors can be tested manually
on Main Menu - Warning - Service/diagnostic - Test Sensors.
Please check the log for the details.
(Main Menu - Warning - Service/diagnostic - Warning - View Log)
- Paper feed failure
During printing, the printer has detected that the paper position is not
where the electronics is expecting it to be. This may be caused by e.g.
the paper is stuck so the stepping motor is slipping, stepping motor
is disconnected or defect, or one of the two paper feed sensors are
disconnected or defect. Press Reset to continue.
The sensors can be tested manually on
Main Menu - Warning - Service/diagnostic - Test Sensors.
63