Table of Contents
Advertisement
BRAILLO
l
5.10 Magnet rack - refitting and adjusting
Before putting the magnet rack back on the printer, make sure that the magnet rack itself is adjusted
as described in the previous section.
When placing the magnet rack in the printer:
Put in the four fastening screws, but do not tighten them. Slide the magnet rack horizontally away
from the printer, so that the magnet rack is touching the horizontal adjustment screws. This will en-
sure that the magnet rack is in the exact same position as before it was taken off the printer.
See next section regarding correct adjustment of the magnet racks.
Note! All explanations refer to one magnet rack, but these adjustments must be done on all
four magnet racks.
Pull back against these positioning
screws on both ends
B 650 SW2.1
89
Advertisement
Table of Contents
