Connect The Printer To The Mains And Computer - Braillo 650 SW2.1 User Manual

BRAILLO
l
2.7

Connect the printer to the mains and computer

Plug the mains cable into the inlet as shown in the figure below.
Note! If the plug on the mains power cable is to be replaced with one that is compatible with the
local electric contact points, observe that the yellow/green wire is the grounding (earthing) wire. Also
make sure that you are connecting to 230 volts!
THE PRINTER'S MAINS CABLE MUST ALWAYS BE CONNECTED TO GROUND!
The connection to the computer can be done in three ways, either by Ethernet, USB, or WLAN.
For USB and Ethernet, the connections are placed on the side of the printer together with the power
inlet.
The ethernet input is a regular RJ45 connector, and the USB input is a regular USB type B connector.
The WLAN is transmitting/receiving via a small antenna placed close to the operator panel.
If you connect to the computer with cable, there is no need to select between USB or Ethernet. The
printer will connect to the input who receives data first. Meaning, if data comes on the ethernet, the
USB will not be operative before the ethernet have finished the transmission.
For instruction on how to install the printer on your computer, see chapter 3 'SETTING UP THE COM-
PUTER' on page 27.
Ethernet connection RJ45
USB connection type B
B 650 SW2.1
Mains inlet
21