Assemble The Sw2 Stacker - Braillo 650 SW2.1 User Manual

BRAILLO
l
2.4

Assemble the SW2 Stacker

Because of it's size, the SW2 Stacker is disasseblied during shipping.
The assembling is done in four steps:
1. Mount the two conveyor belts together to form one long belt
2. Mount the front and rear leg
3. Lift it up and place it on it's legs and put on the belt motor cable cover
4. Fasten the stacking unit
Step 1. Join the belts
Unscrew the transport latches and place the two belts upside down on a flat, clean surface like shown
in the figure below.
Place the end on each belt that has a cable coming out from the roll towards each other.
Fasten the latches, on the cable side, pull the connectors/cables trough the latch before putting the
screws in.
Front end
Fastening holes for
the stacking unit
Fasten the latch with 8
screws
Motor cables
Latch for the cable side
Latch for non-cable side
B 650 SW2.1
Full belt sensor
Fasten the latch with the 4
inner screws
13