Unpacking - Braillo 650 SW2.1 User Manual

BRAILLO
l
2.1

Unpacking

Unpacking and installation can be done by the user.
Any kind of lifting of the printer must always be done from the base of the printer, and should be
done with extreme care.
Make sure that your Braillo printer has not been damaged in transport. Check if the packing is dam-
aged; If so, it is possible that the printer has also been damaged or scratched. If any damages are
found, please contact your distributor or Braillo Norway AS immediately.
The total shipment consists of three pallets, make sure that the following items are enclosed.
Together with the printer:
• Power cable for the printer
• Data cable, USB
• Data cable, ethernet
• User's guide
• Tool kit for service and maintenance
• Test and packing list
Together with the Roll Unwinder
• Roll with paper sample
• Friction bar with correction roll
• Guides for the friction bar
• Shaft for the paper roll
• Compressor
The SW2 Stacker:
• 2 pcs. conveyor belts
• Front leg
• Rear leg
• Stacking unit
If any of these items are missing, please contact your distributor or Braillo Norway AS.
Important !
It is very important that the printer's specified voltage value, 230V, +/- 10%, corresponds with the
local mains power supply available.
If the plug on the mains power cable is to be replaced, note that the yellow/green wire is the ground-
ing (earthing) wire.
THE PRINTER MUST ALWAYS BE CONNECTED TO GROUND!
After the printer is unpacked, we advice that the transport boxes are stored for possible later use.
10
B 650 SW2.1