Table of Contents
Advertisement
BRAILLO
l
Beam and paper shoes - removal and refitting (continued)
3. Remove the paper feed and cutter
Please see section 5.19 'Paper feed and cutter assembly - removing' on page 104 for a description
on how to remove the paper feed and cutter.
4. Remove the top frame
Unscrew the bolts as indicated on the figure below, and then lift the frame carefully upwards and
place it aside.
5. Remove magnet rack A and B
See section 5.5 'Magnet rack - removal'
on page 81
for more info.
Magnet rack A
When assembling, the marking
"UPPER" and "LOWER" on the
paper shoes and beams, must be
facing this side.
Now the paper shoes and beams can be lifted carefully upwards.
Assembly is done in the reverse order. Please note that the marking "UPPER" and "LOWER" on the
paper shoes and beams should be turned to the side where the paper enters the printer.
Top frame bolts
B 650 SW2.1
Magnet rack B
Paper feed
and cutter
97
Advertisement
Table of Contents
