Paper Cutter - Alignment - Braillo 650 SW2.1 User Manual

BRAILLO
l

5.20 Paper Cutter - alignment

If the fixed blade on the cutter has been removed, it needs to be adjusted when putting it back. If
the fixed blade is not aligned with the roll blade, the cutted edges on the paper might get a little torn
instead of a clean cut. Often this could be a problem when the roll blade is going in one direction, but
ok when going the oposite way.
To adjust the alignment, loose all the ten fastening screws a little, then adjust the fixed blade back or
forth with the eccentric adjustment bolts.
It is possible to see the cutting edge on the fixed blade through the inspection opening.
Eccentric
adjustment
Fastening screws
Inspection openings
B 650 SW2.1
Eccentric
adjustment
105