Table of Contents
Advertisement
BRAILLO
l
4.11 Display messages
When there is a problem, the display will show what has happened e.g. "Printer halted, Printer cover
open". And it will stay like that until the error is fixed. Then the display will change to "Printer halted,
Press continue to resume". By pressing Continue the printer will resume the printing from where it
was before the error.
- Press continue to resume
- Out of paper
The printer has run out of paper and is waiting for paper.
When paper is detected, the display will change to "Press continue to
resume".
- Printer cover open
This occurs when one or more panels on the printer cover are open.
When the side panels are put back in place, the display will change to
"Press continue to resume".
- Stacker is full
The stacker belt is full, and the sheets must be removed.
When the sheets are removed, the display will change to "Press con-
tinue to resume".
- At paper sensor
The sheet has not been detected at the paper sensor in the stacking
unit within a certain time after the sheet was cutted. This could be
caused by e.g. a paper jam. Correct the problem and push a sheet
under the paper sensor, and display will change to "Press continue to
resume".
B 650 SW2.1
61
Advertisement
Table of Contents
