Messages And Error Messages - Braillo 400 S 3 Series User Manual

BRAILLO NORWAY AS
●
3.4 Messages/error messages
The text in the display can be divided into three groups; Messages, alarms and error messages. With
messages, the printer operates normally. With some alarms, the printer can be operated to a certain
degree, while other alarms are like error messages, in that the printer cannot be operated, and RESET
PRINTER must be used.
The audio alarm (BEEP) is sounded for both alarms and error messages.
Messages:
1.
P inter
FER empty
2.
NB ! Line Length
Minimum 36 Char
3.
Mag . Rack A
03E -05- 09-14
4.
Mag . Rack A
24
When "Dump buffer" is used, and the input buffer is
empty, the message "BUFFER empty" is shown on the
display. The printer is then ready to begin a new print job.
Note: If there is text remaining in the buffer and "Dump
Buffer" is not used, the text will appear at the beginning
of the next print job.
When PRINT VALUES is used, and the line length is set
to less than 36 characters, this message will appear on
the display. To print the current values, fi rst set the line
length to 36 characters or more.
If there is detected one or more defect magnet(s) -when
45
the printer is turned on, -when pressing reset, -or while
the printer is running, this message will appear on the
display. For more information - see chapter 3.6 "Selftest
on magnets".
If there was detected some problems with the magnets
45
during printing, and the problem is intermittent, this mes-
sage will appear in the display. For more information -
see chapter 3.6 "Selftest on magnets".
B 400 Series 3